Table of Contents
Advertisement
Chapter 1 GENERAL DESCRIPTION
PITCH
2
3
3
4
1
MANU.
AUTO
4
PROD. END
5
EMERGENCY
6
RESET/ORIGIN
7
STEP
8
production
9
counter
PUT IN
MAGAZINE
10
TAKE OUT
MAGAZINE
11
Page 4-2
-
black To decide the lifting height of the step of the magazine lifter
rotary
switch
A switch to select the manual operation and the automatic operation
-
black
Manual operation : Function 7, 8, 10, 11 are possible.
rotary
Automatic operation : Automatic operation.
switch
AUTO : To finish production.
red
Start the line to cancel this command.
(PB)
For each mode :
-
red
To emergency stop the machine.
Whether magazines are there or not, down the lifter to the
magazine supply position.
-
yellow
(It is also to reset the machine when there is a trouble or an
(PB)
error, about this, it is mentioned later.)
Whether magazines are there or not, down the lifter step by
step.
-
white
Decide the stop pitch with the "pitch" rotary switch.
(PB)
When the machine produced boards which are as many as the
number of the counter which is set beforehand, the machine
-
-
-
will stop to produce automatically.
Move the supply conveyor for a while till the magazine move to
the position of the limit switch.
Put a magazine into the lifter when the lifter is on the magazine
green
supply position, there is not a magazine on the lifter and a
(PB)
magazine is on the position of the limit switch which is on the
supply conveyor.
Move the discharge conveyor for a while after the magazine
move through the position of the limit switch. (Even if there is
green
not a magazine.)
(PB)
Section 4 BASIC OPERATION
This lamp will tune on.
033C-E-OMA04-A01-01
Advertisement
Table of Contents
