Turning The Power On; Auto Power Off Function - Yamaha PSR-E263 Owner's Manual

NOTE
• This instrument cannot charge the batteries. Use only the
specified charger device when charging.
• Power will be automatically drawn from the AC adaptor if an
AC adaptor is connected while batteries are installed in the
instrument.
 Setting the battery type
Depending on the battery type to be used, you may
need to change the battery type setting on this instru-
ment. Alkaline (and manganese) batteries are cho-
sen by default. After installing new batteries and
turning the power on, make sure to set the Battery
Type appropriately (rechargeable or not) via Function
number 022 (page 14).
NOTICE
• Failure to set the battery type may shorten the amount of
the battery life. Make sure to set the battery type correctly.

Turning the Power On

Set [MASTER VOLUME] to the MIN position, then
press the [ ] (Standby/On) switch to turn on the
power.
Press and hold the [ ] (Standby/On) switch for
about a second to set the instrument to standby
mode.
CAUTION
• Even when the [ ] (Standby/On) switch is in standby sta-
tus, electricity is still flowing to the product at the mini-
mum level. Remove the electric plug from the outlet when
the instrument is not to be used for extended periods of
time, or during electrical storms.

Auto Power Off function

To prevent unnecessary power consumption, this
instrument features an Auto Power Off function that
automatically turns the power off if the instrument is
not used for approximately 30 minutes. To disable
the Auto Power Off function, select "Off" in the Func-
tion settings (Function 021).
PSR-E263 YPT-260 Owner's Manual
Setting Up
7