Led Assembly Removal And Installation; Lifter Unit Removal And Installation - Panasonic JU-475-4 Service Manual

12.11 LED Assembly Removal and Installation

(1) Remove the clamp handle and fro n t plate as
described in section 12.2.
(2) Disconnect the J8 connector from PCB.
(3) Remove the LED assembly by sliding it slant
from the cartridge guide assembly.
(4) Reverse the above procedure to reinstall.
(5) The LED can be removed and installed as it is.

12.12 Lifter Unit Removal and Installation

(1) Remove the clamp assembly as described in
section 12.5.
(2) Remove the lifte r shaft clamping retaining ring
and draw o ut the lifte r shaft.
(3) Remove the lifte r unit.
(4) Reverse the above procedure to reinstall.
-21 -