Connecting The Power Cord; Turning On And Off The Power - Canon imageFORMULA CR-150 Setup & Operation Manual

Connecting the Power Cord

Connect the power cord.
Make sure to use only the power cord provided with the scanner.
WARNING
When connecting the power cord, follow these precautions. Failure to do so may
cause a fire or electrical shock.
• Never grasp the power plug when your hands are wet.
• Never plug the scanner into a multiplug power strip.
• Never bundle or tie the power cord around itself or another object. Connect the
power plug securely into the power outlet.
• Use only the power cord and power plug provided with the scanner.
• Connect only to a power outlet of the rated voltage and power supply
frequency (either 100-120 V, 60 Hz or 220-240 V, 50/60 Hz, depending on your
region).
• Do not plug the scanner into a power outlet shared with another device. If you
use an extension cord, make sure that the extension cord is rated for the
current requirements of the scanner.

Turning ON and OFF the Power

Follow the procedures below to turn the scanner power ON and OFF.
Turning ON the Power
A
To turn ON the scanner, press the Power Button.
When you turn ON the power, the Power Button flashes slowly and then
turns solid blue.
IMPORTANT
If the scanner does not work, or the power LED continues to flash, there is a problem
with the scanner. Turn OFF the power, and contact your local authorized Canon
dealer or service representative to have the scanner serviced.
WARNING
If you hear strange sounds, detect smoke or abnormal heat, sense a vibration,
or smell odd odors around the scanner, turn OFF the power immediately and
disconnect the power cord from the power outlet. Contact your local authorized
Canon dealer or service representative to have the scanner serviced.
8