Panasonic MC-3920 Service Manual page 8

Motor
Removing:
1) Detach the body partition and the cord reel ass'y.
2) Remove the motor.
3) Take out the noise suppresser, motor support rubber, lead
wires, and motor support (Fig.10)
Assembling
1) Install the lead wires, motor support rubber, and noise
suppresser to the motor.
2) Set the motor in place in the lower body.
3) Install the body partition and the cord reel ass'y.
REPAIR OF MAIN PARTS
Connection Pipe, Hose
Removing:
1) Disconnect the hose U by depressing the projection in the
hole on each side of the connection pipe (Fig. 1)
Assembling
1) Slide the projection on the hose supporter of the hose into
the holes on either side of the connection pipe (Fig. 2)
Motor support
rubber front
Motor case
rubber
8
Motor support
rubber rear
Motor
Noise
suppressor
unit
(Fig.10)
(Fig.1)
(Fig.2)