Advertisement
6.
OPERATION
Recommendations and Warnings!
• Transfer of fuel must always occur in the presence and under the control of the Operator.
• Keep the dispensing nozzle closed until it is inserted in the container to be filled.
• If the nozzle lever is not completely pressed, the automatic release device will not work.
6.1.
HOW TO DISPENSE FUEL
6.1.1.
Rotate the reset knob in a counter-clockwise direction to completely zero-out the partial indicator. The total indicator cannot be reset to
zero.
6.1.2.
Extract the dispensing nozzle (a) and insert it in the container to be filled.
6.1.3.
Set the starting handle to position ON (b): the pump starts.
6.1.4.
Press the nozzle lever and keep it pressed until you have dispensed the desired quantity.
6.1.5.
When dispensing is finished, set the start handle to OFF (c): the pump stops. Replace the nozzle (d).
6.1.6.
Rehang the tube on the tube support hook, so that it will not be crushed by moving vehicles.
7.
MAINTENANCE
a
7.1.
OPENING AND CLOSING THE CUBE fig.4
Unscrew and remove the three cross-head screws on the left side
of the unit ( A).
Unscrew and remove the three cross-head screws on the right side
of the unit (B).
Lift off the top cover.
To reclose it, perform these steps in reverse order.
7.2.
PERIODIC INSPECTIONS
Weekly checks:
- keep the pump body, tubing and flanges clean to promptly reveal any leaks.
- Keep the dispensing nozzle tube clean and especially the hole
for the excess pressure probe at the end of the nozzle tube fig 6.
- With equal frequency or at least every time the tank is filled,
clean the filter and check valve at the bottom of the tank.
Every three months (or more often in case of doubt) verify the accuracy of the
meter.
7.3.
CLEANING THE PUMP FILTER figs 5 & 7
The pump filter must be cleaned weekly or more often whenever a reduction in
flow rate is noticed.
The frequency required depends most of all on the quantity of fuel dispensed, but
also on other causes as well, such as dispensing fuel immediately after refilling the tank, which stirs up sediment which normally lies at
the bottom.
To gain access to the filter:
• Remove the upper part of the unit, by unscrewing the 6 side screws (see Opening and Closing the Cube)
• Screw off the 2 screws on the filter cover.
• To clean it, it is sufficient to wash it and blow through it.
.
© Jack Sealey Limited
fig.3
Original Language Version
fig.5
fig.6
fig.7
TP955.V2 Issue:2 (H,F) 12/10/21
fig.4
Advertisement
