Installation Steps - Philips EasyKey 7100 User Manual

Step 3 | Change the direction of the latch bolt
You can change the direction of the latch bolt to adjust to
different door opening directions: outward bevel for inward
opening and inward bevel for outward opening.
Latch bolt
Attention
1. Use different specifications of installation kit according to door thickness
2. The default installation kit applies to door thickness of 60 to 90 mm.
If the door thickness is not within this range, please contact us.

Installation steps

The following installation steps apply to right opening doors. For
left opening type, please read the [Pre-installation Instructions]
carefully and complete those necessary reversing operations.
Use the drilling template
1
to drill the needed holes
on the door and mount the
mortise into the door.
6
Latch bolt reversing tailpiece
Directional screw
1. Push the reversing tailpiece upwards to the top
2. Press the latch bolt into the mortise and
rotate it 180 degrees. Then pull it out
3. Push the tailpiece downwarads to the bottom
Change the direction of the screws
4.
depending on your needs
screws must be fixed on the inside of the door,
namely towards the inner unit of the lock)
When you insert the mortise,
2
connect it with the upper and
lower multi lock points (No
such step on wooden doors).
(The directional