Sealey DBG506D Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instruction
manual
1. SAFETY
WARNING! Ensure Health and Safety, local authority and general workshop practice regulations are adhered to when using
‰
tools and equipment.
Avoid shocks, impact, dropping etc.
9
DO NOT use the dial bore gauge if damaged.
8
DO NOT remove output connector lid, without using the output interface. Output should never be connected to anything metal. Doing
8
so could damage the dial indicator.
DO NOT connect any part of the dial indicator to a voltage source. Doing so will damage the circuits within.
8
This is a precision instrument, always return gauge components to the storage case.
9
Remove the battery if the dial indicator is not used for a long period of time.
9
Keep indicator face clean and dry.
9
Maintain the gauge in good and clean condition for best and safest performance.
9
Keep the work area clean, uncluttered and ensure there is adequate lighting.
9
Ensure the work area floor is not slippery; wear non slip shoes.
9
Components to be measured and the dial bore gauge to be stored at room temperature (21°C).
9
2. INTRODUCTION
Digital dial bore gauge for use in precision engineering. Digital display shows both metric and imperial measurements. Measuring range between
0-25.4mm. Features lugged back plate for mounting on magnetic bases.
3. SPECIFICATION
Model no ................................................................DBG506D
Deflection/travel ..................................................... 0-25.4mm
Graduation ................................................................ 0.01mm
4. FEATURES
1. Contact point
2. Spindle
3. Mounting diameter
4. On/off switch
5. Zero-setting
6. Inch/mm switch
7. LCD display
8. Data output interface
9. Battery compartment
10. Dust cap
11. Back cover/lug
5. FUNCTION
5.1. Can be zeroed in any position.
5.2. Metric/imperial can be changed at any point.
5.3. Has two types of data output interfaces: normal or micro USB.
6. OPERATION
6.1.
Clean the contact point spindle with a soft cloth before use.
6.2. Press the On/off switch, the 0.00mm or 0.000mm display
appears and the dial indicator is ready for measurement.
6.3. BATTERY REPLACEMENT
Remove battery compartment lid and replace battery
(SR44) with its positive (+) side upwards.
© Jack Sealey Limited
DUAL READING DIGITAL DIAL BORE GAUGE
DBG506D
MODEL NO:
Original Language Version
DBG506D Issue:1 14/07/21