Advertisement
•
Caution:- Do not hold both swivel arms to avoid any damage when install
the pot-filler.
1.
Ensure to place gasket(A) underneath of faucet to form watertight seal.
2.
Guide the faucet through mounting hole. Slide the washer(B) from
beneath the mounting surface. Install the locknut(C) with the help of
mounting tool(D).
3.
Apply teflon tape to outlet of supply stop(F).
4.
Use faucet inlet supply hose to connect to supply stop(F). You may need
adapter(not included) if supply stop outlet size is not 3/8" compression.
5.
Remove the aerator(G) from the spout by turning counter-clockwise.
Turn on supply stop(F). Check of any leaks. Make sure all the connec-
tion are secure. Open both handles. Flush and allow water to run at full
flow for at least one minute. Turn off water. Replace the aerator(G).
Faucet Installation
3
REV-10 31, 12
Advertisement
