Table of Contents
Advertisement
Subwoofer
This section includes an overview of the
wireless subwoofer.
9
8
25Hz
7
10
1
(Wi-Fi Setup) button / indicator
Trigger Wi-Fi setup for Play-�.
•
•
Press and hold the button for 8
seconds to active the AP mode.
•
Press and hold the button for 4
seconds to active the WPS mode.
•
Press and hold the button for
15 seconds to reset the factory
default settings of the subwoofer.
Action
LED State
Constant
on
Press and
Blink
hold
8
seconds
Press and
Double
hold
4
blink
seconds
8
EN
1
2
3
Status
Connected
/ Pairing
successful
Wi-Fi Access
Point (AP)
mode
Wi-Fi Protected
Setup (WPS)
mode
2 Power/RF link indicator
3 Source (switch Play-fi/FR link/Sub
in mode)
• When FW1 is used as a wired
subwoofer, source switch must be
at Sub in position.
» All network audio functionality
will stop working.
» Wi-Fi is disconnected but Wi-Fi
credentials shall be retained if it is
4
setup previously.
5
» Play-� module can be turned off.
6
• To upgrade �rmware for Play-�
module and MCU via USB service
port, source switch must be at Sub
in position.
4 USB service socket
The USB socket is for service only.
5 Reset button (Pin hole)
Reset device to default setting.
6 Phase 0° - 180° (switch)
7 Sub in (socket)
Use the subwoofer cable to connect
the subwoofer to the soundbar (not
supplied).
8 Crossover 25Hz-150Hz (knob)
9 Gain +/- (knob)
Functional Settings
Gain
Crossover 25 to 150 Hz
Phase
When FW1 as Play-� subwoofer,
above controls and functions are not
applicable.
AC in ~ socket
10
Connect to the power supply.
Default
-6 dB to +6 dB
0 or 180 degree
0 dB
-
0 degree
Advertisement
Table of Contents
