Table of Contents
Advertisement
Air Conditioner
Owner's Manual
Important Safety Information
Operating Instructions
The Controls on Your Air Conditioner
Care of Product
Installation Instructions
Important Electrical Safety
Window Installation
Through-the-Wall Installation
Helpful Information
Things That Are Normal
If Something Goes Wrong
Before You Call for Service
GE Service Numbers
Warranty
GE Answer Center
800.626.2000
GE Appliances
49-7362-1
2-98 CG
Standard and Easy Mount
Cool Only:
Heat/Cool:
Heat Pump: AJHS 08
®
AJCS 06
LZ
AJCS 08, 10 AZ
AJES 06
LS
AJES 08
AS
AJES 10
DS
AS
3
4
8
24
25
Advertisement
Table of Contents
Related Manuals for GE AJCS 06 LZ
Summary of Contents for GE AJCS 06 LZ
-
Page 1: Air Conditioner
Installation Instructions Important Electrical Safety Window Installation Through-the-Wall Installation Helpful Information Things That Are Normal If Something Goes Wrong Before You Call for Service GE Service Numbers Warranty ® GE Answer Center 800.626.2000 GE Appliances 49-7362-1 2-98 CG Standard and Easy Mount... -
Page 2: Need Help
Before you call for service, there are a few things you can do to help us serve you better. Welcome to the GE family. We’re proud of our quality products and we believe in dependable service. You’ll see it in this easy-to-use manual and you’ll hear it in the... -
Page 3: Important Safety Information
IMPORTANT SAFETY INFORMATION READ ALL SAFETY INFORMATION BEFORE USING • This air conditioner must be properly installed in accordance with the Installation Instructions before it is used. • Repair or replace immediately all electric service cords that have become frayed or otherwise damaged. -
Page 4: Temp Control
HEAT PUMP MODELS When the outdoor temperature is lower than 25 F., heat is provided by the electric heater in the air conditioner instead of by the heat pump. NOTE: The electric resistance heater in the 115-volt heat pump model operates during defrost when the outdoor coil temperature is below 36 F. -
Page 5: Fan Switch
Cooling/Heating Descriptions FOR NORMAL COOLING FOR MAXIMUM COOLING OR HEATING Select HIGH COOL with the Select HIGH COOL or HIGH thermostat at maximum HEAT with the thermostat cool. at mid point. Limits heat temp Fan Switch On Heat/Cool models, the fan switch lever is located in a hole through the control panel. -
Page 6: Care & Cleaning
If they are clogged with dirt or soot they may be professionally steam cleaned, a service available through your GE service outlet. To clean, use water and a mild detergent. Do not use bleach or... - Page 7 Replacement filters are available from your salesperson, GE dealer, GE Service and Parts Center or authorized Customer Care® servicers.
-
Page 8: Installation Instructions
Installer: Leave these instructions with the appliance. Owner: Keep these instructions for future use. Important Notes • For personal safety, this air conditioner must be properly grounded. • It is important to have the wall outlet and circuit checked by a qualified electrician if there is any doubt as to whether a proper ground exists. -
Page 9: Before You Begin
Before you begin IMPORTANT: Be sure to remove the shipping pad inside the air conditioner next to the compressor. • Phillips-head • Adjustable wrench screwdriver • Ruler or tape • Wood saw AJES and AJHS models have filler panels. Directions begin below. -
Page 10: Window Requirements
• These instructions are for a standard double- hung window. You will need to modify them for other types of windows. • The air conditioner can be installed without the filler panels if needed to fit in a narrow window. See the window opening dimensions to the right. - Page 11 Locking plate Remove screw 4 Remove and discard the shipping screw on the back of the air conditioner to allow removal of the air conditioner from the case. Remove screw 5 Pull the bottom corners of the air conditioner and slide it out of the case.
- Page 12 Installation Instructions Prepare the Window 1 Mark the centerline of the stool. Measure ¤ ² on both sides for the from the centerline 13 panel cuts. Centerline Stool ¤ ² Sill Install the Sill Supports Assemble the sill supports. Do not fully tighten the spacer mounting screws at this time.
- Page 13 NOTES: • On narrow sills, there may not be enough room to use the lock nut. • A deep offset sill may require a longer adjusting bolt than the standard hex head bolt provided. • On wood sills use the large washer between the bolt head and the sill.
- Page 14 Installation Instructions Install the Case in the Window Peel off the backing from the bottom window gasket. 2 Place the gasket on the stool and over the brackets, even with the rear edge, sticky side down. Bottom window gasket 3 Carefully slide the empty case into the window until the holes in the case line up with the holes in the panel angles.
- Page 15 7 Place the vinyl window gasket over the case top gasket. Insert the panel tabs through the slits in the gasket. Cut the gasket on each side to the width of the window. Panel tab Vinyl window gasket Install the Window Gasket and the Locking Bracket 1 Cut the foam top window gasket to the window width.
- Page 16 Installation Instructions Replace the Air Conditioner in the Case Carefully slide the air conditioner back into the case. 2 Attach the power cord to the base pan with the clamp. 3 When the wall outlet is to the left, extend the cord under the unit and hold it in place with the clamp.
-
Page 17: Parts Included
(left) Sill channel Type A (6) Tools Needed • Phillips-head screwdriver • Ruler or tape measure • Level Top mounting rail Air conditioner Type B (15) • Scissors or knife • Pencil • Drill Foam top window gasket Window locking... - Page 18 • These instructions are for a standard double- hung window. You will need to modify them for other types of windows. • The air conditioner can be installed without the accordion curtains if needed to fit in a narrow window. See the window opening dimensions to the right.
- Page 19 3 Remove the screw and the locking plate to unlock the air conditioner. 4 Remove and discard the shipping screw on the back of the air conditioner to allow removal of the air conditioner from the case. 5 Pull the bottom corners of the air conditioner and slide it out of the case.
- Page 20 Installation Instructions Read carefully, then follow step-by-step Prepare the Case 1 Install the top mounting rail with type B screws. 2 Attach the sill channel with type B screws. Align the holes on the bracket of the sill channel with the holes in the case. Sill channel Install the Case in the Window 1 Open the window and center the case in the...
- Page 21 Install the Window Gasket and the Locking Bracket 1 Cut the foam top window gasket to the window width.
- Page 22 Installation Instructions When the wall outlet is to the left, extend the cord under the unit and hold it in place with the clamp. Clamp 4 Reinstall the locking plate with the tab behind the wall case flange. Tighten the screw. Power cord 5 Reattach the front grille.
-
Page 23: Through-The-Wall Installation
Support Requirements for the Air Conditioner The air conditioner wall case may be installed flush with the inside wall or flush with the outside wall. The finished sides of the opening should be structural wall members. -
Page 24: Helpful Information
Helpful Information Things That Are Normal Noise P I N G ! "CLICK" D R I P WHIR! Explanation You may hear a pinging noise caused by water being picked up and thrown against the condenser on rainy days or when the humidity is high. -
Page 25: If Something Goes Wrong
• Clean the filter at least every 30 days. See the Care and Cleaning section. • When the air conditioner is first turned on you need to allow time for the room to cool down or warm up. - Page 26 Notes...
- Page 27 Notes...
- Page 28 Notes...
- Page 29 You can rest easy knowing that all your valuable household products are protected against expensive repairs. Place your confidence in GE and call us in the U.S. toll-free at for more information. *All brands covered, up to 20 years old, in the continental U.S.
- Page 30 It contains appliance properly. information you If you have questions, will need should or need more you require service. information call the Our service number GE Answer Center is 800-GE-CARES 800.626.2000. (800-452-2737). Model Number Serial Number Model Number Serial Number ®...
-
Page 31: Ge Service Numbers
We provide expert repair service, scheduled at a time that’s 800-GE-CARES convenient for you. (800-432-2737) Service Contracts With a service contract GE Consumer Service will still be there 800-626-2224 after your warranty expires. Parts and Accessories Individuals qualified to service... -
Page 32: Air Conditioner Warranty
Staple sales slip or cancelled check here. Proof of original purchase CONDITIONER date is needed to obtain service under warranty. WARRANTY For service, call 800-GE-CARES. What Is Covered FULL ONE-YEAR WARRANTY For one year from date of original pur- chase, we will provide, free of charge,...