Connecting To Video Equipment - Hitachi CMP307XU User Manual

Connecting to Video Equipment

(such as a video disc player, a DVD player, or a video camera)
Read Usage Notes (
these steps:
(1) Choose an appropriate site and install the product on a level table where the stand is secure.
Install the monitor to have ready access to a power socket available.
(2) Make sure that the monitor's power switch is off.
The monitor is shipped with the power switch off.
(3) Make sure that the video equipment's power switch is off.
(4) Interconnect the signal input terminal on the monitor rear panel and the video equipment's
signal output terminal to each other using an optional cable.
(5) Insert one end of the power cable included into the rear-panel power cable connector and
the other end into a power socket.
If a power adapter is used, ground the grounding wire to avoid electrical shocks and radio
interference. (Complete grounding before connecting the power plug to a power supply. Before
disconnecting the grounding wire, be sure to disconnect the power plug from the power supply
first.)
(6) Turn on the monitor, then the video equipment's to make sure that a display image appears
on the monitor screen.
For instructions on turning on the monitor and adjusting its display images, see "Operating
Instructions" (
13
Power cable
Power cable
connector
VIDEO2 INPUT [COMPONENT]
AUDIO
(MONO)
R L P /C
R R
If video equipment with an S video input terminal is used, cabling by the S video cable is
recommended to provide finer video quality. (If an S video input terminal and a video
input terminal connect to the monitor at the same time, S video input would govern.)
to ) carefully to ensure maximum safety before proceeding to
3 6
to ).
21
Monitor rear panel
VIDEO1 INPUT
AUDIO
(MONO)
P /C Y R L VIDEO S-VIDEO
B B
Video equipment
(such as a video disc player,
a DVD player, and a video camer)
Use if the video
equipment has an
S video input terminal
11