Makita DLS110 Instruction Manual page 32

4. Push the wireless activation button on the tool
Fig.66: 1. Wireless activation button 2. Wireless
activation lamp
5. Pull the switch trigger of the tool. Check if the
vacuum cleaner runs while the switch trigger is being
pulled.
push the wireless activation button on the tool.
Description of the wireless activation lamp status
Fig.67: 1. Wireless activation lamp
meaning of the lamp status.
Status
Color
Standby Blue
Green
registration
Cancelling Red
tool
registration
Others Red
Off
Cancelling tool registration for the
vacuum cleaner
Perform the following procedure when cancelling the
tool registration for the vacuum cleaner.
1. Install the batteries to the vacuum cleaner and the
tool.
2. Set the stand-by switch on the vacuum cleaner to
Fig.68: 1. Stand-by switch
3.
Press the wireless activation button on the vac-
press the wireless activation button on the tool in the
same way.
Fig.69: 1. Wireless activation button 2. Wireless
activation lamp
Wireless activation lamp
On Blinking
-
NOTE:
stop blinking in blue when there is no operation for
2 hours. In this case, set the stand-by switch on the
activation button on the tool again.
NOTE:
a switch operation of the tool.
NOTE:
may vary depending on the location and surrounding
circumstances.
NOTE: When two or more tools are registered to one
vacuum cleaner, the vacuum cleaner may start run-
ning even if you don't pull the switch trigger because
an other user is using the wireless activation function.
Duration
2 hours
lamp will automatically turn off when no operation is performed
for 2 hours.
When
the tool is tool is running.
running.
20 seconds Ready for the tool registration. Waiting for the registration by the
vacuum cleaner.
2 seconds
lamp will start blinking in blue.
20 seconds Ready for the cancellation of the tool registration. Waiting for the
cancellation by the vacuum cleaner.
2 seconds
wireless activation lamp will start blinking in blue.
3 seconds
tion function is starting up.
-
If the cancellation is performed successfully, the wire-
less activation lamps will light up in red for 2 seconds
and start blinking in blue.
NOTE:
red after 20 seconds elapsed. Press the wireless acti-
vation button on the tool while the wireless activation
lamp on the cleaner is blinking. If the wireless acti-
vation lamp does not blink in red, push the wireless
32 ENGLISH
Description
-