Rear Panel Connectors; Specifications - JVC BC-D2300U Instruction Book

OTHERS

Rear panel connectors

Names Functions
SDI IN SD digital serial signal input
SDI OUT Active through output
REF External sync input
REF Loop-through
HD SERIAL OUT 1 HD digital serial signal output
HD SERIAL OUT 2 Same as above
HD SERIAL OUT 3 Same as above
CVBS Analog composite input
Y Analog component Y input
Pr Analog component Pr input
Pb Analog component Pb input
ALARM [ALARM] connector/RS-232C
REMOTE-IN Remote control input
REMOTE-OUT Remote control bridge
REMOTE-IN, REMOTE-OUT terminal pin assignment
5 1
9
6
Note:
● For the REMOTE connection, use a straight cable
which contains twisted paired lines for the signals of
TxA and TxB, RxA and RxB.
Installing the power cable hook
Hook
18
Types Remarks
BNC
BNC
BNC
BNC
BNC
BNC
BNC
BNC The optional BC-D231 is required.
BNC
BNC
BNC
D-SUB 9-pin male, inch screw
D-SUB 9-pin female, mm screw
D-SUB 9-pin female, mm screw
Pin Signal
I/O Contents
number name
1 NC — Unconnected
2 TxA O Transmission A
3 RxB I Reception B
4 SG — Signal ground
5 NC — Unconnected
6 SG — Signal ground
7 TxB O Transmission B
8 RxA I Reception A
9 NC — Unconnected
1.
Before connecting the power cable, install the supplied hook as
shown on the left.
2.
After connecting the power cable, lower the hook to secure the
power cable in place.

Specifications

5
Input signal
Video and audio
Sync signals
5
Output signal
Video and audio
5
Quantization
Video resolution
Audio resolution
5
Signal delay amount
Video system
Audio system
5
Conversion mode
5
Power supply
5
Power consumption
5
External dimensions
Remarks
(WHD)
5
Weight
RS-485
5
Using environment
RS-485 Installation place
Allowable operating
temperature
Allowable operating
humidity
Allowable storage
temperature
RS-485
5
Provided accessories and
RS-485
options
: SD digital serial signal (SMPTE259M) ................... 1 line
0.8 Vp-p, 75 ohms unbalanced, active-through
Bit rate: 270 Mbps
Embedded audio signal: 4 ch, sampling frequency of 48 kHz
: Sync signal, 75 ohms unbalanced, loop through .... 1 line
B.B: 0.45 Vp-p (NTSC)
HD-SYNC: Positive and negative bipolarity tri-sync signal of 600 mVp-p ± 300 mVp-p
: HD digital serial signal
(SMPTE292M) ..................................................... 3 lines
0.8 Vp-p, 75 ohms unbalanced
Bit rate: 1.485/1.001 (1.483516) Gbps, 59.94 Hz
Effective scanning lines: 1080 lines (1080I), 720 line (720P)
Embedded audio signal: 4 ch, sampling frequency of 48 kHz
: 10 bits
: 20 bits
: 1 frame or 1 frame - 90H, the shortest delay setting not available
: The same delay as the video delay time, can be adjusted by ±30 msec.
: Three types (4:3 material, letter box material, squeezed material)
: AC 120 V, 50 Hz/60 Hz
: 35 W
: 430 mm x 489 mm x 50 mm
(16-15/16" x 19-5/16" x 2") (excluding fan motor and connectors)
: 6.2 kg (13.7 lbs.)
: In a room (install on a table or a rack)
: 10˚C to 40˚C (50˚F to 104˚F)
: 30%RH to 80%RH (with no condensation)
: –20˚C to 60˚C (–4˚F to 140˚F)
: Warranty card x 1
Instruction manual x 1
Service center list x 1
Power cable (2.5 m) x 1
Rack mount bracket x 2
Screw (M4) x 4
Screw (M5) x 4
Hook (for power cable) x 1
19