Replacing The Airclean Exhaust Filter; Replacing The Active Airclean 30/Hepa Airclean 30 Exhaust Filter; Replacing One Type Of Exhaust Filter With Another; When Changing The Filter Please Note - Miele Classic C1 Exclusive PowerLine Operating Instructions Manual

 Close the dust compartment lid.

Replacing the AirClean Exhaust Filter

(Fig. 26)
Do not use more than one exhaust
filter at a time.
Replace this exhaust filter every time
you start a new packet of Miele Fil-
terBags. Every packet of original Miele
FilterBags contains one AirClean Ex-
haust Filter. Multipacks contain 4 Air-
Clean Exhaust Filters.
 Open the dust compartment lid.
 Release the filter grille and raise it
upwards. Grasp the used AirClean
Exhaust Filter by the clean, unsoiled
section (see arrow) and take it out.
 Replace it with a new AirClean Ex-
haust Filter.
If you wish to install an Active AirClean
30 or HEPA AirClean 30 Exhaust Filter,
see "Replacing one type of exhaust fil-
ter with another".
 Close the filter grille.
 Close the dust compartment lid.
Replacing the Active AirClean 30/
HEPA AirClean 30 Exhaust Filter
(Fig. 27)
Do not use more than one exhaust
filter at a time.
Replace these exhaust filters if the
TimeStrip® exhaust filter change indi-
cator is completely red (Fig. 12).
The display will be completely filled with
red after approximately 50 operating
hours; this corresponds to approxi-
mately one year of average use. You
can continue vacuuming in this case.
However, the suction power will be re-
duced as will the effectiveness of the fil-
ter.
 Open the dust compartment lid.
 Lift the exhaust filter and remove it.
 Insert a new exhaust filter, making
sure it goes in properly, then push it
down into position.
 Press the TimeStrip® exhaust filter
change indicator.
After approx. 10–15 seconds a thin red
line will appear in the left-hand side of
the display.
If you wish to install an AirClean Ex-
haust Filter, see "Replacing one type
of exhaust filter with another".
 Close the dust compartment lid.
Replacing one type of exhaust filter
with another
Depending on the model, your vacuum
cleaner will be equipped as standard
with one of the following exhaust filters:
a AirClean
b Active AirClean 30 (black)
c HEPA AirClean 30 (white)
Do not use more than one exhaust
filter at a time.

When changing the filter please note

1. If you wish to replace exhaust filter a
with filter b or c, you must com-
pletely remove the filter grille before
you install the new exhaust filter.
en-US
21