Digital Audio Mpeg" Setting; Speaker Setting - Kenwood Sovereing DV-5700 Instruction Manual

"Digital Audio MPEG" Setting

When a DVD recorded in MPEG Audio is played, this
setting makes it possible to select the audio signal output
from the digital output connector.
At the factory, the player has been set to "Bitstream" to
enable digital connection to an AV amplifier with built-
in MPEG decoder. For the nonexistent decoders, set the
"Digital Audio" setting to "PCM".
Setting items
" " : Select to return to the previous screen.
"Bitstream" : The signal is output as a bitstream.
Select when connecting a component containing
MPEG decoder.
"PCM" : The signal is converted onto 48 kHz (2CH)
PCM signal before being output. Select when
connecting a component without MPEG decoder.
Operation procedure
1.
Set the mode switch of the joystick remote to the
Purple position.
2.
While the player is in stop mode, press
the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3.
Press to open the setup screen.
ENTER
4.
In the setup menu, select "Digital Audio MPEG" by
tilting the joystick up or down and press
56
Digital Audio
PCM Down Conversion
Dolby Digital
DTS
MPEG
Speaker Setting (Custom)
Speaker Setting (Quick)
Audio During Search
Dynamic Range Control
Audio Filter
5.
Select the audio output by tilting the joystick up or
down, and press
memory.
1
and tilt
SET UP
.
ENTER
7
7 Bitstream
7 PCM
to enter the selection in
ENTER
Chapter 6: Various Setups

"Speaker Setting"

When an associated system component is connected to
the 6CH. OUTPUT jacks of the player, this setting is
required on the player.
At the factory, the player has been set to the standard
setting with which the speakers can reproduce the 6-
channel signals as soon as the connections are made.
This setting can be changed according to each listening
environment. When you want to change this setting, be
sure to perform it in the listening area in your own
listening environment.
¶ For the "Speaker Setting" when an AV amplifier
is connected digitally to the player, refer to the
instruction manual of the AV amplifier.
"Speaker Setting (Quick)"
Three kinds of speakers can be set, including the "Center
Speaker", "Surround Speakers" and "SubWoofer".
Operation procedure
1.
Set the mode switch of the joystick remote to the
Purple position.
2.
While the player is in stop mode, press
the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3.
Press to open the setup screen.
ENTER
4.
In the setup menu, select "Speaker Setting (Quick)"
by tilting the joystick up or down and press
5.
Place the cursor on the speaker name you want to set
to "Use" or "Do not use", then press the
1
and tilt
SET UP
.
ENTER
button.
ENTER