Sony DSC-WX50 Service Manual page 14

Ver. 1.2 2012.03
The changed portions from
Ver. 1.1 are shown in blue.
1-9. DC MOTOR WORM (A) BLOCK ASSY REPLACING METHOD
Removal
Disengage the two claws and remove the FG Leaf Spring.
1
Remove the two Sensors.
2
Disengage the three claws and remove the FPC Retainer.
3
Sensor
Claws
FG Leaf
Spring
Sensor
Remove the LF-115 Flexible Board.
4
Top View
Disconnect the Iris Flexible Board
from LF-115 Flexible Board.
Claw Rib
Boss
Claw Rib
Remove the Rear Mirror Plate.
5
Remove the Gear B (Black) and the Gear A (White).
6
Remove the two screws, and remove soldering from the two points, and then remove the DC Motor (A) Block Assy.
7
Screws
Screws
Rear Mirror
Plate
Gear B
(Black)
Gear A
(White)
DSC-WX50_L2
Boss
Claws
FPC Retainer
Back View
LF-115 Flexible Board
Rib
DC Motor Worm
(A) Block Assy
Solders
Screws
Installation
Solder the two locations.
1
Install the DC Motor Worm (A) Block Assy and secure it with two screws.
2
*Tightening torque = 0.0xx ± 0.0xN • m (0.x ± 0.xkgf • cm)
Install the Gear B (Black) and the Gear A (White).
3
Install the Rear Mirror Plate and secure it with two screws.
4
*Tightening torque = 0.0xx ± 0.0xN • m (0.x ± 0.xkgf • cm)
DC Motor Worm
(A) Block Assy
Solders
Screws
Install the LF-115 Flexible Board.
5
Top View
Disconnect the Iris Flexible Board
from LF-115 Flexible Board.
Rib
Claw Boss
Claw Rib
Install the FPC Retainer while fitting the three claws and the boss.
6
Install the two Sensors
7
Install the FG Leaf Spring while fitting the two claws..
8
Claws
1-11
Rear Mirror Plate
Screws
Screws
Gear C
(White)
Gear B
(Black)
Gear A
Gear B
Gear A
(White)
(Black)
(White)
Back View
LF-115 Flexible Board
Rib
Sensor
Claws
Boss
FG Leaf Spring Sensor
FPC Retainer
Gear D
(Black)
Naruto
Gear