Table of Contents
Advertisement
12.
If pressure and return hoses were previously
installed at the locations shown in
Figure
15, remove them.
Note:
Ensure that the hoses do not contact
any hot, sharp, or moving parts. Try to attain as
much clearance from the muffler as possible.
13.
Connect the hydraulic hoses to the hydraulic
control panel. Refer to
on the SH versions and
17
on the EH versions.
Figure 16
SH version shown
1. Hose routing
Figure 17
EH version shown
1. Hose routing
14.
Tighten all of the hydraulic connections and
fasteners.
Figure 14
and
Figure 14
and
Figure 16
Figure 15
and
Figure
g013867
g013866
Completing the Installation
1.
Refit the Twin Spinner assembly.
2.
Connect the black cable and the black pre-routed
cable to the battery negative terminal and the
white cable and the red pre-routed cable to the
battery positive terminal.
3.
Plug the intermediate wire harness into the
power harness connector on the machine
(Figure 18
or
Figure
1. Power harness
1. Power harness
9
19).
Figure 18
2. Intermediate wire harness
Figure 19
2. Intermediate wire harness
g013946
g013948
Advertisement
Table of Contents
