Table of Contents
Advertisement
Audio software
Take note of the following points to extend the life of your equipment.
Always read the instructions provided with the software.
Discs
Choose discs with this mark:
Continued use of irregular shaped
CDs can damage the unit.
Do not
• use CDs with labels and stickers
that are coming off or with adhesive
exuding from under labels and
stickers.
• attach scratch-proof covers or any
other kind of accessory.
• write anything on the CD.
• clean CDs with liquids. (Wipe with a soft, dry cloth.)
• use CDs printed with label printers available on the market.
• load a blank CD-R as it will cause abnormal malfunction and may
damage the CD-R.
Cassette tapes
• Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
• Tape slack can get caught up in the mechanism and should be
taken up before the tape is played.
• Endless tapes can get caught up in the deck's moving parts if used
incorrectly.
• Sound quality may be effected and the cassette tape may become
stuck if you do not adhere to the following.
- Do not use other stickers not included with the cassette tape.
- Place stickers on the cassette tape only as indicated.
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the remedies indicated in the chart do not
solve the problem, consult your dealer for instructions.
Reference pages are shown as black circled numbers
Common Problems
The unit doesn't work on batteries.
"UO1" is displayed.
CD
"ERROR" is displayed.
CD-RW cannot be read.
Play doesn't start or display is incorrect.
Cassette
Recording not possible.
Poor sound quality.
The cassette cannot be ejected or the lid can't
be closed when loading a cassette.
Radio
A lot of noise.
Matsushita Electric Industrial Co., Ltd.
Web Site: http://www.panasonic.co.jp/global/
Troubleshooting guide
2
.
Is the AC mains lead connected to the unit? Disconnect when using batteries.
Have the batteries been inserted correctly? Check that the poles (+ and –) are correctly aligned.
Replace the batteries or use household AC power.
Indicates an incorrect operation. Read the instructions.
The disc was incompletely formatted. Use the recording equipment to fully format the disc before recording.
Clean the CD.
Wait for an hour for condensation to dry, then try again.
Make sure the label is facing up.
Replace the CD if it is scratched, warped, or irregularly shaped.
Has the cassette's tab been removed? Cover the hole with adhesive tape.
Clean the heads.
7
The batteries are flat. Replace the batteries or connect to household AC power.
Press [
PLAY] then [ /
STOP/EJECT].
Is another remote control being used? Use it further away from this unit.
Is a TV on? Move the unit away from the TV or turn it off.
8
RQTT0622
Specifications
Frequency range
FM
AM
(Only for areas except for United Kingdom and Continental Europe)
Sampling frequency
Decoding
Beam source
Semiconductor laser (wavelength 780 nm)
Pickup
Bølgelengde
Laserstyrke
No. of channels
Wow and flutter
D/A converter
Track system
Monitor system
Recording system
Erasing system
Frequency range
Normal position
Speakers
Full range
Jacks
Output
Power output
(For Australia and New Zealand)
(For areas except for United Kingdom, Continental Europe,
Australia and New Zealand)
Power requirement
AC
(For United Kingdom, Continental Europe,
Australia and New Zealand)
(For others)
Battery
• Do not use rechargeable type batteries.
Memory back-up
4.5 V (Three R6/LR6, AA, UM-3 batteries)
• Do not use rechargeable type batteries.
Dimensions (WxHxD)
Mass
(For United Kingdom, Continental Europe,
Australia and New Zealand)
(For others)
Power consumption in standby mode:
(For United Kingdom, Continental Europe,
Australia and New Zealand)
(For others)
Note
Specifications are subject to change without notice.
Mass and dimensions are approximate.
87.50–108.00 MHz (50 kHz steps)
522–1629 kHz (9 kHz steps)
520-1630 kHz (10 kHz steps)
44.1 kHz
16 bit linear
780 nm
Ingen farlig stråling sendes ut
(med sikkerhets-beskyttelse)
2 channel, stereo
Less than possible measurement data
1 bit DAC
4 track, 2 channel, stereo
Variable sound monitor
AC bias
Multi Pole magnet
50–12000 Hz
8 cm 4
x 2
PHONES: 3.5 mm stereo (32 )
57 W (PMPO)
60 W (PMPO)
230-240 V, 50 Hz
Power consumption: 13 W
110-127 V/220-240 V, 50/60 Hz
Power consumption : 14 W
9 V (Six R14/LR14, C, UM-2 batteries)
408 x 163 x 273 mm
3.3 kg without batteries
3.4 kg without batteries
1.1 W
1.6 W
2
5
En
RQTT0622-1B
M1203YS1014
Hide quick links:
Advertisement
Table of Contents
