Page 8
• This clock radio shall not be exposed to dripping or splashing. • Do not place any sources of danger on the clock radio (e.g. liquid filled objects, lighted candles).
• Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With this unit, you can: • listen to FM radio; •...
d COLOR • Select mood light color. e REPEAT ALARM/BRIGHTNESS CONTROL • Snooze alarm. • Adjust display brightness. f RADIO • Turn on/off radio. • Turn off the ringing alarm. g SLEEP • Set sleep timer. h MIN/PRESET +/- • Adjust minute. • Select a preset radio station. • Turn on/off mood light. •...
• Select alarm source for Alarm 2. p Power cord & Antenna q Battery tray r VOL • Adjust volume. Get started Always follow the instructions in this chapter in sequence. Install battery Warning • Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. • Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
The clock radio has “plug and set” feature. When power is connected, the clock is set automatically. Select time zone Check if the time of the clock radio is consistent with the local time. If not, adjust the time zone settings according to your location. In standby mode, press TIME ZONE.
Set clock In standby mode, you can set clock manually. Select DST (daylight saving time) mode For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time. In standby mode, press and hold 12/24H·DST for two seconds. The clock advances by one hour. » • To exit DST mode, repeat the above operation. • To select 12/24 hour format, press Listen to FM radio Tune to FM radio stations...
Store FM radio stations automatically You can store up to 20 FM radio stations. Press RADIO to turn on the radio. Press and hold PROG for two seconds. The clock radio stores all the available FM radio stations and » broadcasts the first available station automatically. Store FM radio stations manually Tune to an FM radio station.
In standby mode, you can set two alarms to ring at different time. Select alarm sound For the alarm sound, you can select buzzer, your last heard radio, or the melody stored in the clock radio. Adjust AL1/RADIO·BUZZ· 1 or AL2/RADIO·BUZZ· 2 to select alarm sound for Alarm 1/Alarm 2.
The alarm snoozes and repeats ringing five minutes later. » To adjust alarm interval (in minutes), press REPEAT ALARM repeatedly. Other features Set sleep timer This clock radio can switch to standby mode automatically after a preset period. Press SLEEP repeatedly to select the sleep timer period (in minutes). When the sleep timer is activated, » To deactivate the sleep timer, press SLEEP repeatedly until [OFF] (off) appears.
Enjoy mood light The clock radio features decorative mood light with different colors. To turn on/off mood light: Press to turn on mood light. • You can press brightness level. To turn off mood light, press To select mood light color: Press COLOR.
Specifications Amplifier Rated Output Power Tuner Tuning Range Sensitivity - Mono, 26dB S/N Ratio Search Selectivity Total Harmonic Distortion Signal to Noise Ratio General information AC power Operation Power Consumption Standby Power Consumption Dimensions - Main Unit (W x H x D) Weight - With Packing - Main Unit 0.6W RMS FM: 87.5 - 108 MHz FM: <22 dBu FM: <28 dBu FM: <3% FM: >45 dB 100-240 V~, 50/60Hz <3W <1W 135 x 135 x 60.5 mm 0.6 kg...
If you encounter problems when using this clock radio, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the clock radio is nearby and the model number and serial number are available. No response from the unit •...
Page 20
Note • The type plate is located on the bottom of the apparatus. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ Please inform yourself about the local separate collection system for electrical and electronic products.