LG One:Quick Share Owner's Manual page 34

2
FCC Compliance
Statement
This equipment has been tested and found
to comply within the limits of a Class B
digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against
harmful interference in a residential
installation.
This equipment generates, uses, and
can radiate radio frequency energy and
if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation.
If this equipment does cause harmful
interference to radio or television
reception (which can be determined by
turning the equipment on and off), the
user is encouraged to try to correct the
interference by using one or more of the
following measures:
- Reorient or relocate the receiving
antenna.
- Increase the separation between the
equipment and the receiver.
- Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced
radio/TV technician for help.
Caution: Changes or modifications
not expressly approved by the party
responsible for compliance could void the
user's (or your) authority to operate the
equipment. Only peripherals (digital input/
output devices, terminals, printers, etc.)
certified to comply with the Class B limits
may be attached to this product. Operation
with non-certified peripherals is likely
to result in interference to radio and TV
reception. Only shielded signal cables may
be used with this System.
Indoor use only
FCC Caution: Any changes or modifications
not expressly approved by the party
responsible for compliance could void the
user's authority to operate this equipment
and for indoor use only, use outdoors or in
other modes not covered by this manual
may violate the FCC regulation and violate
the user authority to use the product.
Specially, within the 5.15-5.25 GHz
band, U-NII device is restricted to indoor
operations to reduce any potential for
harmful interference to co-channel MSS
operations.