Electrolux ECP955C Instruction Book page 6

Citrus juicer
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
INSTRUCTIONS FOR USE
• Before using the appliance, all removable parts (not the motor case) must be washed.
• Remove the lid and unravel the cable stored in the compartment beneath the motor base (Refer to Fig.1)
• Plug in the appliance to the main supply.
• Cut the fruit (oranges, lemons, grapefruits etc.) in half.
• Position the half fruit on the juice cone.Press the fruit down lightly and the motor will automatically begin the juice process.
For best results, adjust the hold on the fruit to ensure that all parts of the flesh are squeezed.
• Do not put excessive pressure on the Juice Cone: if the motor starts getting louder or the speed of the motor decreases
significantly, there is too much pressure being exerted on the cone.
• The motor stops automatically when the fruit is removed from the cone or when it ceases to be pressed.
• Juice Tank with Drain, lift drain up when squeezing the fruit, press down the drain to let the juice drain out of the tank. When
the tank is empty lift up the drain. (Refer to Fig.2-HOLD, Fig.3-DRAIN).Place a suitable glass under the drain before it is pushed
down to release the juice.
NOTE: Let the appliance cool for 5 minutes after every 2 minutes use.
Assemble the juicer (shown in the diagram on page 3) by sliding the
accessories over the motor shaft locating the juice drain in the open-
ing on the motor base.
The dust cover is not used during operation. Make sure you use the
correct sized juice cone for the fruit being juiced.
4
EN

Advertisement

Table of Contents
loading

Table of Contents