Operator's Responsibilities - Haier HB WH-Filter M10 Manual

Operator's responsibilities

You have purchased a durable and service-friendly
product. However, this also entails obligations. For
a perfect function you must ensure:
●Intended operation.
●Regular inspections and service work.
Changes in the water quality may have to be made
in the settings. Prerequisites for the function and
safety of the product are inspections, regular
inspections (every 2 months) by the operator and a
half-yearly (every 6 months) routine maintenance
(EN 806-5) of the entire drinking water installation.
A further prerequisite for function and warranty is
the replacement of wear parts at the prescribed
intervals.
Intended operation
The intended operation of the product includes
commissioning, operation, decommissioning and, if
necessary, recommissioning. Proper operation of
the product and the drinking water installation
requires regular checks, servicing and operation in
compliance with the operating conditions used for
planning and installation.
Controls
(by the operator)
Recommends that the operator regularly carries out
and logs the following checks:
●Water pressure: If the pressure conditions
change, the product settings may also have to be
changed.
●Operating condition of the product (soiling).
●Checks whether (error) messages have been
issued.
Inspection
(according to EN 806-5 by the operator)
Inspection activity
Check contamination
of the filter material
Leak test, visual
inspection
Note for products WITHOUT
Interval
active BWT-DES registration
every 2 months
every 2 months
Maintenance according to EN 806-5
(by customer service or authorized specialist)
Replacement of wearing parts
The operator must ensure that parts that are subject
to wear and ageing during the service life of the
product are replaced by a specialist installer.
The detailed replacement cycles can be found in the
maintenance manual.
anually, respectively after a water flow of
Refill filter
75 / 200 / 300 m (C1002 /C2002 / C3002)
material
Replace
when the water pressure drops
downstream
filter
ervery 24 months
material
O-Rings
Drain hose
Pressure tank
HBCF-C1002
HBCF-C2002
1 bag (6 kg / 4 litres)
HBCF-C3002
1 bag (6 kg / 4 litres)
We recommend that you enter into a maintenance
agreement with your installer or the after-sales
service team.
Cleaning
Plastic parts must only be cleaned with a soft, damp
cloth; do not use any solvents, detergents or acid
cleaners.
Required
Required
10
3
the filter,
every 3 years
every 5 years
every 10 years
Filter gravel GAC Bewasorb
– 1 part
2 part
3 part
Note for products WITH active
BWT-DES registration
Required
Required
at least