Panasonic CF-VEB531U Manual page 11

4
Press the computer fi rmly against the port replicator.
This will cause the expansion bus connector on the
bottom of the computer to connect to the expansion
bus connector of the port replicator.
CAUTION
While connecting the computer to the port replicator:
Do not attempt to move the port replicator.
Do not open the display wider than necessary (180° or more).
It is impossible to remove the battery pack and the hard disk drive.
If the computer malfunctions while the port replicator is attached, disconnect the
port replicator and check to see if the computer operates normally. If the computer
operates normally, the port replicator may be malfunctioning. Contact your
Technical Support.
Disconnecting
1
Power off the computer and close the display.
2
Slide the lever all the way back. The computer's
connector disengages the expansion bus connector
of the port replicator.
CAUTION
After sliding the lever, do not suddenly release it. The lever may relock.
Do not slide the lever while pressing against the computer from above.
Doing so could damage the computer.
3
Lift up the computer to remove it from the port rep-
licator.
E
11