Advertisement
UV Lamp Installation
IMPORTANT
Make sure the appliance is unplugged.
1. Unplug the product from the power outlet
and remove the lamp from the EPS housing.
Figure 7
IMPORTANT
Be careful when handling the lamp as the
tube is made of glass and may break.
2. Position the lamp carefully over the housing
without releasing it (Figure 8).
Figure 8
3. Connect the UV lamp to its power cable con-
nector (Figure 9).
Figure 9
4. Snap the connector into the housing and at-
tach the cable to the clip (Figure 10).
Figure 10
5. Plug the product into the power outlet and
press the "RESET UV LAMP" button as
shown in Figure 11.
Figure 11
IMPORTANT
the product by following the instructions
in Chapter 6, Cleaning and Maintenance.
RESET
UV LAMP
7
Advertisement
