Diagrams - Sony SA-FT1H Service Manual

SA-FT1H/WPFT1/SS-CNPFT1/MSPFT1/SRPFT1
• Circuit Boards Location
Note on Schematic Diagrams:
• All capacitors are in µF unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
1
• All resistors are in Ω and / W or less unless otherwise
4
specified.
• 2 : nonflammable resistor.
• C : panel designation.
Note:
Note:
Les composants identifiés par
The components identi-
une marque 0 sont critiques
fied by mark 0 or dotted
line with mark 0 are criti- pour la sécurité.
Ne les remplacer que par une
cal for safety.
Replace only with part piéce portant le numéro
spécifié.
number specified.
• A : B+ Line.
• B : B– Line.
• Voltage is dc with respect to ground under no-signal
(detuned) condition.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production
tolerances.
no mark : POWER ON
∗
: Impossible to measure
• Signal path.
F
: LINE
8
All manuals and user guides at all-guides.com
SECTION 2

DIAGRAMS

LED board
POWER AMP board
MAIN board
Note on Printed Wiring Boards:
• X : parts extracted from the component side.
•
C
Q
B E
Q
B C E
Q
B C
VOL board
CONTROL/AC board
: Pattern from the side which enables seeing.
These are omitted.
These are omitted.
E