To Operate Your Air Purifier - Beko ATP5100I User Manual

To Operate Your Air Purifier

7
1. Connect the appliance with power source,
one "Beep'" can be heard.
2. Touch the Power button once, "Beep'" can
be heard, the appliance starts to run under
under the default "Medium" setting, and its
corresponding indicator will illuminate. Touch
the "Power button" again if you want to turn
off the appliance.
Hold and Touch the "Pow-
NOTE:
er button" for 2 seconds if you
C
want to enter into the sleep
mode. To recover, hold and Touch
the "Power button" for 2 seconds
again.
3. And you can select your required speed set-
ting by following the operation described in
"CONTROLS INTRODUCTION". After select,
the corresponding indicator of selected speed
setting will turn on.
4. After turn on the air purifier and select your
required speed setting, you can activate the
timer by following the operation as below:
Touch down Timer button on the control
panel, one beep "Beep" can be heard. There
are 3 settings including 2H, 4H and 8H for se-
lection. After selecting your required timing,
the indicator of selected timing will illumi-
nate. When the timer expires, the air purifier
will power off automatically and the indicator
of selected timing will extinguish.
12 / EN
The appliance is of mem-
NOTE:
ory function. When being turned
C
on again, the appliance will work
according to the speed setting
saved last time.
Replace copy with:The Air Purifier will re-
sume using the last speed setting when it is
switched back on.
5. When the filter change indicator illumi-
nates in white, it is time to change the HEPA
filter. Please change the HEPA filter by follow-
ing the operation described in the section of
"CHANGE THE HEPA FILTER".
Air Purifier / User Manual