Figure 3-3: Emulation Board (Ie-78K0-Ns-P04) Jumper Positioning; Table 3-13: User Reset Mode; Table 3-14: Dcan Transmit Buffer Selection - NEC IE-78K0-NS-P04 User Manual

IE-78K0-NS-P04, IE-780948-NS-EM4

Figure 3-3: Emulation Board (IE-78K0-NS-P04) Jumper Positioning

<6> Connect the emulation board (IE-78K0-NS-P04) to the option board (G-78K0H).
<7> When user clock as main clock is used, the main system clock can be mounted by using a
parts holder or a crystal oscillator (see chapter clock setting).
<8> Setup of the probe board (IE-780948-NS-EM4)
Jumper JP1
Jumper Position
(1 - 2)
(2 - 3)
Jumper JP2
Jumper Position
(1 - 2)
(2 - 3)
28

Table 3-13: User RESET mode

User RESET
To probe
User Reset (IE) connected to the probe (default)
Pull-up User Reset (IE) pull-up by resistor (10K)

Table 3-14: DCAN Transmit Buffer Selection

DCAN out
Pin emulator Reserved
FPGA DCAN transmit line from FPGA via transistor to probe (default)
JP1
JP2
JP4
JP8
JP7
Function
Function