Sony VID-P110 Service Manual page 13

Preparation
Connections for external control from a computer
After performing the connections on the previous
page, make the connections shown below to control
this unit from the connected computer.
Note
When you control the VID-P110 from a computer,
special software is required. To program in this
software, refer to the "Interface Manual".
12
Adjusting the camera
When the picture is not upright, rotate the camera up
and down and move it from left to right to adjust.
VID-P110 (Rear panel)
RS-232C
(D-sub 9-pin, male)
Adjusting the arm lights
RS-232C cable
Adjust the angle of the arm lights depending on the
object.
RS-232C connector
of the computer
If the light supporting arms loosen
If the arms will not stay upright, the screw in the base
may be loose. After turning off the POWER switch,
tighten the screw as shown below.
Adjusting the Parts
The arm cannot stand upright.
Opening in the base for
adjusting the light
supporting arm
Tighten the screw inside
slightly, but not excessively.
Cross-headed screwdriver
Collapsing the Unit
Follow the instructions below to collapse the VID-
P110 for transportation or convenience.
1
Fold both arm lights down onto the base.
Arm lights
2
Rotate the camera parallel to the camera stand.
Carefully fold down the camera stand toward the
operation panel side until it locks.
Camera
Rotate parallel to
Camera stand
the camera stand.
Cautions
• Lay the unit down flat. Do not try to stand it on its
rear or sides. Doing so may cause the unit to fall
resulting in damage or personal injury.
• Do not try to pick up this unit by the camera stand.
This may cause the unit to malfunction, and may
cause you injury.
NOT this way NOT this way NOT this way
13