Fujitsu LifeBook E8310 Technical Procedure

Hide thumbs Also See for LifeBook E8310:

Download this manual

Wireless Card Replacement

ESD Precautions are required when working on this LifeBook computer.

Make sure the LifeBook is turned off before beginning this procedure.

1. Turn the LifeBook over. Release and

remove the battery.

3. Turn the LifeBook up and use a plastic pry

tool to release the Hinge Cover tabs on

both sides.

Technical Procedure

LifeBook E8310

2. Remove 3 screws from inside the Battery

Bay. Remove one screw from the rear of

the Lower Cover.

4. Open the LifeBook. Use a plastic pry tool

to remove the Hinge Cover.

Page 1 Technical Procedure LifeBook E8310 Wireless Card Replacement ESD Precautions are required when working on this LifeBook computer. Make sure the LifeBook is turned off before beginning this procedure. 1. Turn the LifeBook over. Release and 2. Remove 3 screws from inside the Battery remove the battery.
Page 2 5. Disconnect the Keyboard Cable from the 6. Slide the Keyboard forward and tilt it up. System Board. Disconnect the Touch Stick cable from the System Board. Remove the Keyboard. 7. Remove 7 screws from the Keyboard Plate. 8. Disconnect both Wireless Antenna Cables Disconnect the Speaker Cable from the from the Wireless Card.
Page 3 11. Secure the Wireless Card with 2 screws. 12. Connect the Black Wireless Antenna Cable to the Auxiliary connector on the Wireless Card, and the Gray Wireless Antenna Cable to the Main connector. 13. Secure the Keyboard Plate with 7 screws. 14.
Page 4 17. Make sure that the Hinge Cover tabs are 18. Insert 3 screws into the Battery Bay. secure on both sides. Insert one screw into the Lower Cover.Insert 3 screws into the Battery Bay. Insert one screw into the Lower Cover. 19.