ADJUSTMENT PROCEDURES
1.Adjustment Conditions
Power supply voltage DC 9.0 V.
Input the suitable signal for each adjustment.
It shifts to TEST MODE by pressing in order of [OUT] [OUT][IN] [IN]
[VOLUME-] [VOLUME
When in TEST MODE, the items can be changed by pressing
of joystick, and the values can be changed by pressing [VOLUME ] or
[VOLUME-]
.
2.LCD Adjustment
< Adjustment conditions >
In VIDEO MODE, input monochrome10 step signal from VIDEO IN.
Go to TEST MODE and adjust in order of the following.
Adjust each video signal value by default value (COLOR/TINT/ BLACK:
CENTER, DIMMER: MAX, AUTO DIMMER: OFF ).
1 )
Adjustment
-
B
B
Observe VG(CS1, pin 8 ) by Synchro - scope.
Adjust [RGB AMP] to become [4.0V
voltage (V
-
)
B
B
2)
Adjustment
-
B
W
Observe VG(CS1, pin 8 ) by Synchro - scope.
Adjust [BRIGHT] to become [2.9V
voltage (V
-
B
W
3) Red Adjustment
Observe VR(CS1, pin 7 ) by Synchro - scope.
Adjust
[SUB R] to become [2.9V
voltage (V
-
).
B
W
4) Blue Adjustment
Observe VB(CS1, pin 6 ) by Synchro - scope.
Adjust [SUB B] to become [2.9V
voltage (V
-
B
W
5) VCOM Adjustment
Observe VCOM(CS1, pin 9 ) by Synchro - scope.
Adjust [COM AMP] to become wave Form [4.0V
The steps should be like figure 1 by the above - mentioned adjustment.
] [VOLUME-] [VOLUME ]
-
P
).
P
-
P
)
[RETURN] [POSITION].
-
0.1V] between Black - Black
P
P
0.1V] between Black - White
P
-
0.1V] between Black - White
P
0.1V] between Black - White
P
-
0.1V]
P
P
_
_
13
[
]
or
]
[