Auto Pc Adjustment - Sanyo PLV-HD2000E Owner's Manual

DISPLAY ADJUST
Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots and Picture Position to conform to your
computer. Auto PC Adjustment function can be operated as follows.
Auto PC Adj.
1 Press MENU button and ON-SCREEN MENU will appear. Press
POINT LEFT/RIGHT button to move a red frame pointer to
DISPLAY ADJUST Menu icon.
2 Press POINT DOWN button to move a red frame pointer to
AUTO PC Adj. icon and then press SELECT button twice.
This Auto PC Adjustment can be also executed by pressing
AUTO PC ADJ. button on Side Control or on Remote Control
Unit.
Store adjustment parameters.
Adjustment parameters from Auto PC Adjustment can be memorized
in this projector. Once parameters are memorized, setting can be
done just by selecting Mode in SYSTEM SELECT Menu (P27). Refer
to step 3 of MANUAL DISPLAY ADJUSTMENT section (P32).
NOTE
G Fine sync, Total dots and Picture Position of some computers can
not be fully adjusted with this Auto PC Adjustment function. When
image is not provided properly through this function, manual
adjustments are required. (Refer to page 31, 32)
G Auto PC Adjustment function cannot be operated in Digital Signal
input on DVI terminal and "480i", "575i", "480p", "575p", "720p
(HDTV)", "1035i (HDTV)", "1080i/50 (HDTV)" or "1080i/60 (HDTV)"
is selected on SYSTEM SELECT Menu (P27).
30

AUTO PC ADJUSTMENT

DISPLAY ADJUST MENU
DISPLAY ADJUST Menu icon
Set a red frame pointer
to item and press
SELECT button.