[2] Connection of LAN cable
To connect to the network, it is required to use the UTP (Unshielded Twisted Pair)
strait cable with RJ-45 plug. There are two different types of cables depending on
whether the network is constructed with 10Base-T or 100Base-TX. Prepare the Hub
(10Base-T or 100Base-TX) to distribute the network cable if required.
1
Disconnect the AC plug from the projec-
tor.
2
Connect the UTP strait cable to the LAN
port on the network board.
3
Connect the UTP strait cable to the hub.
Projector
Use the UTP cross cable when you connect the computer and projector directly not using the
hub.
When you connect the projector into the 10Base-T network, use cable with category 3 or 5.
When you connect the projector into the 100Base-TX network, use cable with category 5.
The length of cable between hub and projector should be less than 100m.
Connection of LAN cable
Hub
(10BaseT, 100Base-TX)
UTP strait cable
PJ-Net Organizer
OWNER'S MANUAL
13