Sharp MD-DR470HS Service Manual page 19

Servo Pre-Manual Adjustment
M A N U 1
PLAY
T M P $ $
SKIP UP SKIP DOWN
A h
SKIP UP SKIP DOWN
B h
SKIP UP SKIP DOWN
E h
SKIP UP SKIP DOWN
F h
SKIP UP SKIP DOWN
L O N P
SKIP UP SKIP DOWN
A B
SKIP UP SKIP DOWN
S a
SKIP UP SKIP DOWN
S b
SKIP UP SKIP DOWN
e f
SKIP UP SKIP DOWN
P C H
SKIP UP SKIP DOWN
e f
SKIP UP SKIP DOWN
G C H
SKIP UP SKIP DOWN
T C
SKIP UP SKIP DOWN
S E
SKIP UP SKIP DOWN
S F
SKIP UP SKIP DOWN
a b
SKIP UP SKIP DOWN
S A
SKIP UP SKIP DOWN
S B
SKIP UP SKIP DOWN
T H
* When the [STOP] button is pressed in specific condition, the "TEST MODE STOP" state is set.
* When you press the [Remote Controller BASS] button with the laser ON (lid open), the laser power shifts as follows.
Play back
BASS
L O N P
* In the specific setting display state the setting change digit changes when the [REC] button is pressed.
• In the case of the setup value two digits.
1st digit (initial value)
• In the case of the setup value three digits.
1st digit (initial value)
* In the specific state the setting changes in the range of "0h to Fh" when the [VOLUME UP/DOWN]
button is pressed.
: Pre-Manual Adjustment menu
: Temperature code indication
$ $ : Temperature code
: A signal offset (AINO) measurement
: Measurement value
: B signal offset (BINO) measurement
: Measurement value
: E signal offset (EINO) measurement
: Measurement value
: F signal offset (FINO) measurement
: Measurement value
: Laser ON (play power)
: AB signal level measurement (ABMAXO)
: Measurement value
: A-ATT (focus) tentative setting
: ATT setting
: B-ATT (focus) tentative setting
: ATT setting
: Pit section EF signal level measurement (LPFEFO)
: Measurement value
: Pit section adjustment COUT level setting
: COUT level setting
: Groove section EF signal level measurement (LPFEFO)
: Measurement value
: Groove section adjustment COUT level setting
: COUT level setting
: TCRS signal level measurement (TCRSMIO)
: Measurement value
: E-ATT (tracking) initial setting
: ATT setting
: F-ATT (tracking) initial setting
: ATT setting
: AB input level measurement (LPFABO)
: Measurement value
: A-ATT (focus) initial setting
: ATT setting
: B-ATT (focus) initial setting
: ATT setting
: TCRS signal offset (TCRSO) measurement
: Measurement value
Record power Maximum power
BASS
L O N R
L O N
2nd digit
REC
REC
2nd digit
REC
– 19 –
MD-DR470H/MD-DR480H
M
BASS
3nd digit
REC
REC