Required Equipment; Connections And Setup - Philips NXP BGU7004 GPS LNA User Manual

NXP Semiconductors

4. Required Equipment

In order to measure the evaluation board the following is necessary:

5. Connections and setup

The BGU7004 GPS LNA evaluation board is fully assembled and tested. Please follow
the steps below for a step-by-step guide to operate the evaluation board and testing the
device functions.
1. Connect the DC power supply to the V
2. Jumper JU1 is connected between the V
3. To evaluate the power on settling time t
4. Connect the RF signal generator and the spectrum analyzer to the RF input and the
5. Turn on the DC power supply and it should read approximately 5 mA.
6. Enable the RF output of the generator; the spectrum analyzer displays a tone of
7. Instead of using a signal generator and spectrum analyzer one can also use a
8. For noise figure evaluation, either a noise-figure analyzer or a spectrum analyzer with
UM10491
User manual
DC Power Supply up to 30 mA at 1.5 V to 2.85 V;

Two RF signal generators capable of generating an RF signal at the operating

frequency of 1575.42 MHz, as well as the jammer frequencies 850 MHz, 1713.42
MHz, 1850 MHz and 1851.42 MHz;
An RF spectrum analyzer that covers at least the operating frequency of 1575.42

MHz as well as a few of the harmonics, so up to 6 GHz should be sufficient;
"Optional" a version with the capability of measuring noise figure is convenient;

Amp meter to measure the supply current (optional);

A network analyzer for measuring gain, return loss and reverse Isolation;

Noise figure analyzer and noise source;

Directional coupler;

Proper RF cables.

the desired supply voltage, between 1.5 V and 2.85 V, but never exceed 3.1 V as it
might damage the BGU7004.
V pin of the BGU7004.
en
possible to use a separate voltage on the V
by a pulse generator. In this case jumper JU1 should be removed. The definition of
t is the time from 10 % to 90 % of the maximum signal level and for t
on
90 % to 10 % of the maximum signal level.
RF output of the evaluation board, respectively. Do not turn on the RF output of the
Signal generator yet, set it to -40 dBm output power at 1575.42 MHz, set the
spectrum analyzer at 1575.42 MHz center frequency and a reference level of 0 dBm.
around –25 dBm at 1575.42 MHz.
network analyzer in order to measure gain as well as in- and output return loss.
noise option can be used. The use of a 15 dB noise source, like the Agilent 364B is
recommended. When measuring the noise figure of the evaluation board, any kind of
adaptors, cables etc between the noise source and the evaluation board should be
avoided, since this affects the noise performance.
Rev. 1.0 — 14 June 2011
BGU7004 GPS LNA EVB
, and GND terminals. Set the power supply to
cc
terminal of the evaluation board and the
cc
and the power off settling time t
on
eventually this voltage can be supplied
en,
UM10491
, it is also
off
the time from
off
© NXP B.V. 2011. All rights reserved.
7 of 15