Adjusting The Brightness And Contrast - Sony CPD-E100 Operating Instructions Manual

x Using the control button
1
Display the main MENU.
Press the center of the control button to display the main
MENU on your screen.
MENU
2
Select the menu you want to adjust.
Highlight the desired menu by moving the control button
towards the rear to go up (M), towards the front to go down
(m), and left (<) or right (,) to move sideways.
FRONT
MENU
REAR
3
Adjust the menu.
Move the control button left (<) or right (,) to make the
adjustment.
MENU
4
Close the menu.
Press the center of the control button once to return to the
main MENU, and press again selecting EXIT to return to
normal viewing. If no buttons are pressed, the menu closes
automatically after about 30 seconds.
x Resetting the adjustments
Press the RESET button. See page 12 for more information on
resetting the adjustments.
RESET
MENU
MENU
Adjusting the brightness and
contrast
Brightness and contrast adjustments are made using a separate
BRIGHTNESS/CONTRAST menu.
These settings are stored in memory for all input signals.
1
Move the control button in any direction.
The BRIGHTNESS/CONTRAST menu appears on the
screen.
BR I GHTNESS / CONTRAST
2 6
6 8 . 7 k H z 8 5 . 0 H z
the resolution
1 0 2 4 X 7 6 8
of the current
input signal
The horizontal and vertical frequencies of the current input
signal are displayed in the BRIGHTNESS/CONTRAST
menu. If the signal matches one of this monitor's factory
preset modes, the resolution is also displayed.
Move the control button m/M to adjust the
2
), and </, to adjust the contrast
brightness (
(6).
The menu automatically disappears after about 3 seconds.
2 6
the horizontal
and vertical
frequencies
of the current
input signal
9
US