Advertisement
8. MAINTENANCE
8.1.
Have the sprayer serviced by a qualified repair person using only genuine replacement parts. This will ensure that the
safety of the sprayer is maintained.
DO NOT attempt any maintenance or repairs that are not included in this manual.
8
DO NOT use solvents to clean sprayer.
8
8.2.
AFTER USE MAINTENANCE
8.2.1.
Dispose of any residual liquid from the sprayer tank, by returning it back to it's original container. Clean up any spills immediately
as per fluid manufactures instructions.
8.2.2.
Wash out the tank with clean water and after cleaning, pour the water into a suitable container.
8.2.3.
Refill the tank with clean water and run the sprayer for up to 3 minutes, removing any residue from the pump, water hose, control
handle, spray pipe and nozzle into a suitable container. Ensure all water has been removed from the system.
8.2.4.
Wipe away any remaining moisture with a dry cloth.
NOTE: Dispose of any contaminated water properly according to local regulations.
8.3.
WATER ABSORPTION STRAINER CLEANING
WARNING! Ensure that the tank has been washed out and is free from any chemicals.
‰
8.3.1.
Unscrew and remove the tank lid and then the tank strainer.
NOTE: The water absorption strainer is located at the bottom of the tank.
8.3.2.
Locate the water absorption strainer (fig 18) and carefully remove the strainer from the water pipe (fig 19).
8.3.3.
Remove the top cap and clear any debris from the inside of the strainer (fig 20).
8.3.4.
Replace the top cap and reattach the strainer to the water hose.
8.3.5.
Refit the tank strainer and then the tank lid.
NOTE: The water absorption strainer prevents debris from entering the pump. Periodically clean the water absorption strainer to
maintain optimal performance.
8.4.
CONTROL HANDLE STRAINER CLEANING
8.4.1.
Fully unscrew the nut on the control handle (fig 21) and detach the water pipe.
8.4.2.
Remove the filter and remove any debris from the inside of the strainer (fig 22).
8.4.3.
Replace the strainer and reattach the water pipe and fully tighten nut on the control handle.
NOTE: The control handle prevents debris from entering the spray hose. Periodically clean the control handle to maintain optimal
performance.
8.5.
TANK STRAINER CLEANING
8.5.1.
Unscrew and remove the tank lid.
8.5.2.
Remove the tank strainer and clear any debris from the inside of the strainer (fig 23).
8.5.3.
Refit the tank strainer and then the tank lid.
8.5.4.
NOTE: The tank strainer prevents debris from entering the tank. Periodically clean the tank strainer to maintain optimal performance.
9. STORAGE
9.1.
Wash out the sprayer as section 8.1 and ensure that the sprayer is completely free from moisture.
9.2.
Store the sprayer in a child free, safe, clean, dry indoor location that is away from direct sunlight, has good ventilation and does not
freeze.
WARNING! Frozen liquids that remain in the sprayer may cause breakdown or damage to the pump during operation.
‰
© Jack Sealey Limited
Fig.18
Fig.21
Original Language Version
Fig.19
Fig.22
CP20VGBS Issue 2 (2,3) 18/02/22
Fig.20
Fig.23
Advertisement
