Advertisement
6. TELESCOPIC POLE
6.1.
ADJUSTING THE TELESCOPIC HEIGHT
WARNING! Prior to adjusting the telescopic height, switch off the tool and remove the battery cartridge.
‰
6.1.1.
Loosen the joint nut (fig 5) by turning it clockwise.
6.1.2.
Extend the pole to the required length (fig 6).
6.1.3.
Re-tighten the joint nut (fig 7) by turning counter clockwise.
NOTE: the telescopic pole can be extended from 2.1m to 2.6m.
WARNING! Ensure the joint nut is securely tightened to avoid any slippage.
‰
7. ATTACHMENT TO POLE
7.1.
ATTACHMENT OF TOOL HEAD TO THE TELESCOPIC POLE
WARNING! Before fitting tool head to pole switch off and remove the battery.
‰
7.1.1.
Turn the attachment locking nut (fig.10) at the end of the telescopic pole so
that the tool head can be inserted. Push the head home (fig.11) making sure
the electrical contacts at the end of both components are aligned correctly
(telescopic pole contact (fig.8), tool head contact (fig.9)).
7.1.2.
Tighten the attachment locking nut to secure both components together (fig.10).
7.1.3.
To separate again reverse sections 7.1.1 and 7.1.2
fig.10
Attachment locking nut
8. SHOULDER HARNESS
8.1.
Securely fasten the buckle (fig.12) and hook the harness clasp onto the telescopic poles hook fixing bracket (fig.13).
8.1.1.
Place the harness over your right shoulder only (fig.14).
9. MAINTENANCE
9.1.
CLEANING
9.1.1.
Use a clean cloth to remove dirt, dust, oil, grease etc.
DO NOT use solvents.
8
© Jack Sealey Limited
fig.5
fig.12
fig.13
fig.14
Original Language Version
fig.6
fig.8
fig.11
Tool Head tube
CP20VTP Issue 1 25/10/21
fig.7
fig.9
Telescopic pole
Advertisement
