GE Centricity MP3510 User Manual page 10

•
You can hurt your fingers if they are caught between the Centricity™ CR
compatible Cassette and the edge of the input slot. Insert the cassette in the
input buffer as described in
keep your fingers clear of the input slot. As soon as the Centricity™ MP3510
takes in the cassette, release it.
10
Supplementary protective earth connector:
Provides a connection between the Centricity™ MP3510 and the
potential equalization busbar of the electrical system as found in
medical environments. This plug should never be unplugged
before the power is turned off and the power plug has been
removed.
Intergrounding connector:
Provides a connection between the Digitizer and other equipment
which might exhibit minor ground potential differences. These
differences may degrade the quality of communication between
different equipment. Never remove connections to this terminal.
Protective earth (ground):
Provides a connection between the Digitizer and the protective
earth of the mains. Do not remove this connection, because this
will have a negative influence on the leakage current.
Power on
Power off
Note that the power cord has to be disconnected from the wall
outlet in order to disconnect the unit entirely from the mains.
Precautions for use in USA only:
Make sure that the circuit is single-phase center-tapped, if the
Digitizer is connected to a 240 V/60 Hz source instead of a
120 V/60 Hz source.
'Reading an image plate' on page 26 . At all times,
5001A EN 20020315