Key Board; Bt Board - Sony GTK-XB60 Service Manual

2-12. KEY BOARD

2 KEY board cable
connector (XP12)
terminal side
front side
1 FFC (BT-KEY)
(XP10)

2-13. BT BOARD

Note 1: When replacing the BT board, be sure to replace the BT board
and the NFC board simultaneously. The BT board cannot re-
place with single. Among the repair parts, the BT board and
the NFC board are supplied as one unit.
1 cushion
2 microphone cable
connector (XP6)
top panel block
front side
BT board
XP6
–
microphone cable
7 KEY board
Note: When installing the KEY board,
align the two bosses and two holes.
5 Remove the KEY board
rear side
top panel block
top side
terminal
side
rear side
3 FFC (BT-KEY)
(XP10)
top side
cushion
rear side
–
3 three screws
(M3 10)
block in the direction of
the arrow.
4 claw
4 Gradually peel off the BT board with
a flathead screwdriver, etc.
Note 3: The BT board is affixed to the top panel with
a adhesive sheet.
When removing the BT board, remove slowly
so that you do not damage the boss, etc. of the
top panel.
BT board
front side
top panel block
adhesive
sheet
5 Peel the BT board off of
the top panel block.
two bosses
GTK-XB60
3 seven screws
(M3 10)
hole
hole
6 FFC (BT-KEY)
(XP8)
boss
4 claw
flathead
screwdriver,
etc.
6 BT board
Note 2: When installing the BT board,
hole
align the two bosses and two
holes.
hole
terminal
side
boss
13