Frigidaire FNGN90JEYS User Manual page 31

PROBLEM
The burners do not work.
The appliance makes noises.
The flame colour is orange
or yellow.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
The oven does not heat up.
The oven does not heat up.
Turnspits do not rotate.
Turnspits do not rotate.
It takes too long to cook the
dishes or they cook too
quickly.
The display shows an error
code that is not in this ta-
ble.
The display shows "12.00".
POSSIBLE CAUSE
There is no gas supply.
The oven is deactivated.
The lamp is defective.
You left the dish in the oven
for too long.
The clock is not set.
The necessary settings are
not set.
There is too much food on
the spits.
Connection spit is not instal-
led properly.
The temperature is too low
or too high.
There is an electrical fault.
There was a power cut.
TROUBLESHOOTING
REMEDY
Check the gas connection.
Some metal parts of the ap-
pliance expand and contract
when they heat up or cool
down. The noises are nor-
mal.
The flame can look orange
or yellow in some areas of
the burner. This is normal.
Activate the oven.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15
- 20 minutes after the cook-
ing process ends.
Set the clock.
Make sure that the settings
are correct.
Check the maximum weight
per each spit. Refer to
"Oven - Hints and tips"
chapter, Cooking tables.
Make sure that the shelf is
pushed till the end and the
connection spit is not pro-
truding from its hole.
Adjust the temperature if
necessary. Follow the advice
in the user manual.
Deactivate the oven with the
house fuse or the safety
switch in the fuse box and
activate it again.
If the display shows the er-
ror code again, contact the
Customer Care Department.
Reset the clock.
31