Philips CMP400/93 User Manual

Philips car entertainment system cmp400

Advertisement

Quick Links

Register your product and get support at
www.philips.com/welcome
CMP400
EN User manual

Advertisement

Table of Contents
loading

Summary of Contents for Philips CMP400/93

  • Page 1 Register your product and get support at www.philips.com/welcome CMP400 EN User manual...
  • Page 2: Environmental Information

    2009 © Koninklijke Philips Electronics N.V. All rights reserved. Specifications are subject to change without notice. Trademarks are the property of Koninklijke Philips Electronics N.V. or their respective owners. Philips reserves the right to change products at any time without being obliged to adjust earlier supplies accordingly.
  • Page 3: Your Car Power Amplifier

    Your car power amplifier Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at www.philips.com/welcome. Introduction With the amplifier, you can enjoy high quality sound performance with powerful bass and beats.
  • Page 4 OUTPUT L/R Connect additional amplifier for additional speakers. • FRONT INPUT L/R Connect car audio with RCA cable. • FRONT INPUT LEVEL Adjust input level (0.3V to 6V). • HI INPUT Connect car audio with the supplied high input connector. •...
  • Page 5: Installation

    REAR HPF/OFF/LPF Select High-pass-filter (HPF), Low-pass-filter(LPF) or • OFF (flat) mode. REAR FREQ Adjust frequency of HPF or LPF from 30Hz to 400Hz. • REAR INPUT LEVEL Adjust input level (0.3V to 6V). • REAR INPUT L/R Connect car audio with RCA cable. •...
  • Page 6: Connect Speakers

    Drill the holes with driller of approximately 3mm in diameter. Mount the unit with the supplied screws. Connect speakers Note • Use speakers with an impedance of 2 to 8 ohm (4 to 8 ohm when used as a bridged amplifier). •...
  • Page 7: Connect Car Audio

    Option 3: Tri-mode: connect 6 speakers 4 ohm 4 ohm 4 ohm 4 ohm speaker speaker speaker speaker 8 ohm 8 ohm speaker speaker • Make the terminal connection as illustrated below: Connect car audio Option 1: High level input connection Connect the amplifier to your car audio with the supplied High level input connector.
  • Page 8 Left speaker Left speaker Car audio unit Right speaker Right speaker HI INPUT Brown White Blue Green Option 2: Line input connection Connect the amplifier to the car audio with a RCA cable (not supplied). Car audio unit LINE OUT Option 3: Line output connection Connect the amplifier to another amplifier.
  • Page 9: Connect Power

    Connect power Make the power connection as illustrated below: Connect the ground wire from the car to the • Connect the remote wire from the car audio to the • socket. √ With this connection, you can turn on/off the amplifier with the car audio.
  • Page 10: Adjust Frequency

    HPF (high-pass-filter) mode LPF (Low-pass-filter) mode OFF (flat) mode Slide HPF/OFF/LPF to the selected positon. Adjust frequency You can adjust frequency of HPF or LPF from 30HZ to 400Hz. Note HPF/OFF/LPF switch is set at OFF position, the • When the frequency adjustment does not work.
  • Page 11: About The Protector Indicator

    Replace the fuse with the supplied fuses or to buy two fuse that matches the voltage of the damaged fuse (40A). If the fuse gets damaged immediately after it has been replaced, there may be an internal malfunction. In such case, consult your Philips dealer.
  • Page 12: Product Information

    If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (www.philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. 50W x 4...
  • Page 13 Power indicator does not light up. • The connected car audio is not turned on. • The fuse is blown. Replace the fuse with a new one. The sound is too low. • The input level is not set correctly (see ‘Adjust input level’). The sound is interrupted or stopped suddenly.
  • Page 14 [substances or elements] will not result in any severe environmental pollution, any bodily injury or damage to any assets. © 2009 Koninklijke Philips Electronics N.V. All rights reserved.

This manual is also suitable for:

Cmp400

Table of Contents