Advertisement
43
CONNECTOR
INSTALLATION INSTRUCTIONS
Note: Toshiba's 2.5" HDDs are primarily used in notebook devices. Installation
into a notebook varies depending on the system manufacturer. Toshiba's 2.5"
drives that are installed into a desktop PC require a 3.5" installation kit.
1. Determine mounting configuration (can be mounted in either a horizontal or
vertical orientation).
2. Configure drive for system application.
3. Configure the adapter board for the specific system application (if required).
4. Install the I/F cable to the System's 44 pin connector port or adapter board.
Ensure Pin 1 is oriented correctly. (Pin 1 on the cable is usually identified by a
red or blue stripe.)
5. Refer to applicable manuals for software installation instructions.
P/N 480056-F0
08/04
INTERFACE
FIGURE 1 – 2.5" HDD JUMPER LOCATIONS
JUMPER
No Jumper
C-D Jumper
B-D Jumper
B-D Jumper
A-B Jumper
A-C Jumper
MOUNTING HOLES
FIGURE 2 – MOUNTING HOLE LOCATIONS
2.5" Hard Disk Drive Installation Notes - 9.5mm GAS Series
KEY
PIN 20
P28
DRIVE
-
Master Drive
-
Slave Drive
LOW
Master Drive
Slave Drive
HIGH
-
Slave Drive/
-
Prohibit
1
C A
D B
JUMPERS
Advertisement
