Fujitsu Plasmavision P50XHA10WS Service Manual page 24

Model : P50XHA10E
DISPLAY SECTION - LOWER PART
Bottom
Videoboard
P-TE1000E type P-TE1010E type
/I power switch
When pressed while in the "OFF" state, the power indicator lamp lights and the display is placed in the "ON " state, and the power can be turned
"ON" or "OFF" by the remote control or on the control panel of the display. When pressed while in the "ON " state, the power indicator lamp goes
out and the display is placed in the "OFF" state where power is still partly supplied.
RS-232C terminal (RS-232C)
This terminal is provided for you to control the display from the PC. Connect it to the RS-232C terminal on the PC.
When connecting a cable, attach a ferrite core to the cable.
RGB1 input terminal (RGB1 INPUT/DVI-D)
Connect this terminal to the PC's display (digital RGB) output terminal.
*The connection cable No.88741-8000 made by molex Inc. is recommanded.
RGB2 input terminal (RGB2 INPUT/mD-sub)
Connect this terminal to the PC's display (analog RGB) output terminal or decoder (digital broadcast tuner, etc.) output terminal.
Power input terminal
Connect this terminal to the power cable supplied with the display.
When connecting a cable, attach a ferrite core to the cable.
External speaker output terminal (EXT SP)
Connect this terminal to the optionally available speaker.
When connecting a cable, attach a ferrite core to the cable.
*See the speaker instruction manual for more information.
Audio3 input terminal (AUDIO3 INPUT)
Audio2 input terminal (AUDIO2 INPUT)
Audio1 input terminal (AUDIO1 INPUT)
Connect this terminal to the sound output terminal of your VCR, etc.
RGB3 input terminal (RGB3 INPUT/BNC)
+
Connect this terminal to the PC's display (analog RGB) output terminal or decoder (digital broadcast tuner,etc.) output terminal.
*When RGB3 input terminal is connected, Comp.video mode is not available.
Component video input terminal (VIDEO4 INPUT)
Connect this terminal to the component video output (colour difference output) terminal of your HDTV unit or DVD player.
*When Comp.video input terminal is connected, RGB3 mode is not available.
RGB3 synchronization switch (SYNC SW TTL/ANALOG (75 ))
This switch is used to terminate horizontal (H) terminal and vertical (V) terminal, out of RGB3 input terminals, with 75 .
TTL : Does not terminate.
ANALOG (75 ): Terminates.
Video1 input terminal (VIDEO1 INPUT/P-TE1000E)
Connect this terminal to the SCART terminal of your VCR or DVD, etc.
S-Video input terminal (VIDEO2 INPUT/P-TE1010E)
Connect this terminal to the S-video output terminal of your VCR.
Video input terminal (VIDEO1 INPUT/P-TE1010E)
Connect this terminal to the video output terminal of your VCR.
Component video input terminal (VIDEO3 INPUT/P-TE1010E)
Connect this terminal to the component video output (colour difference output) terminal of your HDTV unit or DVD player.
- 20 -