Table of Contents
Advertisement
PREPARATION
CONNECTIONS
Place your HDB60receiver on a firm, level surface with at least a 10cm gap around all sides of the case
and in a position convenient for connection to your television, a mains power outlet and a TV aerial wall outlet
(or the 'flying lead' from your TV aerial, as appropriate).
Please refer to the safety section in Appendix A.
Turn off your television at the mains and disconnect the lead going to the aerial wall outlet (or the flying aerial
lead) and connect this to the ANT IN socket on the rear of the receiver. Connect the aerial cable supplied
from the TV OUT socket on the receiver to the TV set's aerial socket.
Connect the TV SCART socket on the rear of the receiver to a suitable SCART socket on your television.
There may be more than one SCART socket on your television and, if unsure which to use, you should refer
to its manual for guidance.
6r…vhy
If you have a VCR or other equipment connected to your television, please connect the receiver as
described here and refer to Appendix D later when satisfied that the receiver is functioning normally.
Finally, plug the receiver into the mains outlet.
Remove the battery compartment cover from the rear of the remote control handset by lifting the catch
at one side. Insert two AAA (MN2400) sized batteries, taking care to observe the correct orientation as marked
on the inside of the compartment. Replace the compartment cover.
All manuals and user guides at all-guides.com
UW
CvAv
T 86SUÃ
UW ÃD I
T 86SUÃ!
UW
UWÃTph…‡ÃD
D
UW
UWÃPVU
6I U@ II6
UWÃ6r…vhy
- 6 -
Pƒ‡v‚hyÃGrhq†
W8 S
6V 9DP
%WÃ98
G
S
I
1
Advertisement
Table of Contents
