ABB HT580196 Operation Manual page 107

Table of Contents

Advertisement

NOTICE
Nozzle ring press fit for
single inlet turbine casing
NOTICE
© Copyright 2016 ABB. All rights reserved.
Disassembly and assembly
Disassembling and assembling
turbocharger
To ensure the nozzle ring is held in place during operation, it must be
clamped between the partition wall and the turbine casing.
Calculate the press fit (PD) as shown.
If the calculated value (PD) is less than 0.1 mm, an official ABB Turbo-
charging Service Station must be contacted.
Measure the axial and radial clearances (see the section Axial and ra-
dial clearances).
Operation Manual / TPS48-D/E.. - TPS61-D/E..
8
8.3
Page 105

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tps 48e01

Table of Contents