Panasonic 46A2LJ Operating Instructions Manual page 10

Installing or removing disc
Inspection before use
• Has the correct grinding disc been
mounted for the object to be ground?
• Has the proper diameter of the
grinding disc been mounted for the
tool rating?
• Has the correct disc been fitted in
compliance safety standards listed
below?
Europe - EN,Australia - AS
CAUTION
• When using, the Grinding disc guard
must be installed on the tool so that
the closed side of the guard always
faces toward the operator.
• Ensure that blotters are used when
they are provided with the bonded
abrasive product and when they are
required;
WARNING:
Always use supplied guard when using
tool. Grinding disc can shatter during
use and Grinding disc guard helps to
reduce chances of personal injury.
01̲Eng̲EY46A2(EU).indd 10
1. Grinding disc
1
guard
2. Spindle
2
3. Grinding disc
guard fixing
screw
3
- 10 -
1. Install the Grinding disc guard, and then
securely tighten the screw.
Make sure
the side.
2. Install the disc flange and the disc to the
spindle in order as shown in the figure.
3. Tighten the clamp nut onto the spindle so
that hollow side faces opposite direction
to the disc.
4. Push the Spindle lock button to secure
the spindle in place, and then use the
clamp nut wrench to tighten the clamp
nut securely.
Spindle lock button
5. To remove the grinding disc, follow the
installation procedure in reverse.
1. Clamp nut
1
2. Grinding disc
3. Disc flange
2
3
2014/07/02 12:01:19