Download Print this page

Haier QDT125SSKSS Owner's Manual page 15

Advertisement

Troubleshooting Tips... Before you call for service
Problem
Detergent left in
dispenser cups
Black or gray marks
on dishes
Dishes don't dry
Control panel
responded to inputs
but dishwasher
never filled with
water
Stained tub interior
Dishwasher won't
run
Control panel lights
go off when you're
setting controls
Water standing in
the bottom of the
tub
Water won't pump
out of the tub
49-55107
Possible Cause
Dishes or utensils are
blocking the detergent cup
Aluminum utensils have
rubbed against dishes
Low inlet water temperature
Rinse agent dispenser is
empty
Door may not be completely
closed
Water valve may be turned
off
White film on inside
surface— hard water
minerals
Fuse is blown or circuit
breaker is tripped
Power is turned off
Reboot your control
Time too long between
touching of selected pads
Air gap is clogged
High drain loop or air gap
not installed
Drain is clogged
What To Do
arm can flush the detergent cup. See the Loading
section.
be keeping the dispenser cup door from opening. See
the Loading section.
Don't place large bowls or pots directly under the
detergent dispenser.
Make sure inlet water temperature is at least 120°F.
Select a cycle that includes heated dry such as HEAVY
or NORMAL.
Check the rinse agent dispenser and fill as required.
Make sure the door is firmly closed.
Make sure water valve (usually located under the sink) is
turned on.
Haier recommends using rinse aid to help prevent hard
water mineral deposits from forming.
for ordering information. Alternatively, purchase Lemi
directions on the label.
appliances from the circuit.
In some installations, the power to the dishwasher is
provided through a wall switch, often located next to the
disposer switch. Make sure it is on.
Turn off power to the dishwasher (at circuit breaker or
wall switch) for 30 seconds, then turn back on.
If the control panel lights go off, touch any pad again and
continue setting controls.
Clean the air gap. See the Care and Cleaning section.
installation.
If you have an air gap, clean it. See the Care and
Cleaning section.
If the dishwasher drains into a disposer, run disposer
clear.
Check to see if your kitchen sink is draining well. If not,
you may need a plumber.
15

Advertisement

loading

This manual is also suitable for:

Qdt125 series14191