Table of Contents
Advertisement
2. Installing the LCD remote keypad
2.2 Installing the remote keypad to the board (optional)
The remote keypad can be mounted on a board by means of an IP54 attachment
(optional).
If an IP65 attachment (optional) is used in combination with an IP54 attachment, the
remote keypad can be installed where it may be splashed with water.
● Never connect the unit to any inverter other than a VF-AS1/PS1 series
inverter or any communication device. Do not use any cable other than
an optional interconnect cable designed specifically for the unit.
Prohibited
If the correct cable was not used, this might cause the unit to break down
and result in an electric shook or fire.
Turn off the inverter, as shown in the figure below.
Tapping screws (4 pieces)
Used to secure the attachment.
IP65 attachment (optional)
Used to be attached to the IP54 attachment
*
Leave a space of 45mm or more
for the interconnect cable.
Warning
Make a hole in the board, as shown in
the figure below.
5.5
Dedicated interconnect cable
(optional)
* The pin configuration of the dedicated
interconnect cable is different from that of
any other commercially available cable.
Therefore, be sure to use the dedicated
interconnect cable.
2-2
115
104
5.5
4-Ф3.5
IP54 attachment
(optional)
Remote keypad
*
Advertisement
Table of Contents
