Sharp HT-SB31D Operation Manual page 18

Bluetooth one touch connection via NFC (continued)
■ NFC connection for audio playback
Check that:
●
Your device (smartphone/tablet) has an NFC
function.
●
NFC function on your device is enabled.
1
Touch your device to the NFC detection area on the main unit. (NFC detection area of your device
must touch to the NFC detection area of the main unit.)
Device
A pop-up window asking whether to proceed with the Bluetooth connection appears on the device.
2
Select <YES>.
●
The 'connected' message appears when the connection is complete.
3
Playback will start automatically, otherwise press play (on remote control or source device).
●
Sound will be heard from the speakers of this unit via audio streaming.
●
Your device must be within 32 feet (10 meters) from the unit.
Bluetooth operation buttons (remote control only)
Press the button to play
or pause.
Notes:
● This product switches to Bluetooth function automatically when NFC tagging was done by your device.
● If your device does not support NFC, or if you wish to listen to audio via Bluetooth connectivity without NFC;
refer "Pairing with other Bluetooth source devices" on the next page.
● Some Bluetooth devices will connect to this product automatically when the device or its Bluetooth mode
was turned on. In such case, it will also change the function selection of this product. If you do not want it to
connect automatically, please disable Bluetooth on your device.
● It takes about 6-8 seconds for a Bluetooth enabled device (eg. smartphone) to establish Bluetooth connection
with this unit via NFC or manual connection.
● If "Empty tag" or similar message appears on your device, touch the device again to the NFC detection area
on the main unit.
NFC
detection
area
Main
unit
Press the button to
skip up.
●
Screen lock function of the device is off.
●
This unit is not in low power consumption
mode.
E-17
Press the button to skip
down.